[syborg tt]

In order for me to be able to install the access door I am going to have to remove all of the parts in the trunk. The good news is most of the parts have already left the trunk and have been installed on the car. So I am feeling like the car is getting closer to getting back together.



Don't hate me as I went to Harbor Freight and bout a disposable panels saw.



and here is why I love the blue tape as all of my measurements are right there.





In order for the panel to follow the shape of the floor I slid the panel up into the curve and slowly pushed it into shape.



Tanks is back out.



You know if it wasn't my car I am sure it wouldn't bother me to cut a giant hole in the trunk floor.







Houston we have a hole.



Next step it to make the floor opening match the access door.





I installed the tank back in to make sure I actually cut the hole in the correct place.



Tanks is back in and I made sure I installed the lines. I wanted to make sure I could get to all of the fittings.



Once I trim up all of the excess I will be able to service the pump, float & fittings.



Holy crud am I making a mess.