[Rodknock]

Been working on the door to fender, and door to quarter panel gaps. Not that they were too awful, but I wanted a little more consistency in them, and a little tighter. I basically just ran my mig along the edges to build them up, and then ground them down.

You can see where these areas are a little wide in some spots, but decent in others.





Didn't mark these but you can see it's a little wide at the top.



A little wide in the middle (like me)



Needs a little build up to make it tighter against the fender. I couldn't move the door further forward, or the rear gap would have been huge.



Bottom along the rocker is perfect. Nothing needed here.



I'm a grinder, not a welder as you can tell













Second round. Adding a little more material