214 Chevy and ScotI thanks for the compliments.
Marty, The wires are stretched out down and across the floor of the car at the moment. Once I get them correctly routed the will come out the fuse panel and loop up and over to the dash area with the exception of a few going to the rear of the car. I have actually contemplated flipping the fuse box so they come out the top.
I finished up the pulleys and the serpentine belt.
Then it was time to test fit the core support and mock up the front end. It’s still in primer until i see what other mods will be needed. It will all come back a part a few more times yet. Took several attempts of shimming the fender supports to get the spacing close. I have been test fitting the radiator and figuring out a mounting strategy. The original radiators bolted directly to the core support with no form of isolation or vibration control. I want to come up with a better solution. If anyone has some mounting options to share I would like to see them.
