[CamaroAJ]

So we're back with work on the Camaro. Well, except this weekend because it was too cold in the shop. The new shop I'm working for is D Built Hotrods. Give us a follow on Facebook or Instagram. Dbuilt.hotrods on Insta and I think its the same on Facebook. CamaroAJ is my personal one where I post the car up.

Anyways I got the car racked up and to work. Last time I worked on the car I made temp brackets because I didn't have any steel to make solid enough brackets to hold things where they needed to be.



With the new brackets made the wheel clears at full lock at ride height. I still have offset upper control arm bushings to install to move the wheel in and get a bit more clearance. Then I use zip screws to hold everything together and sanded the fender to get everything bonded back together.





With the passenger fender ready to bond I test fit the carbon fiber trans tunnel plate that I made and it fit perfectly. Then I pulled the chassis harness out and got it all zip tied up and put away until I'm ready for some more wiring now that I have most of it roughed in.