After a little racing break we needed to get back at the front end. That measurement of 71-1/2 is 2 inches wider than the stock rear-end width. I had planned for the front to be slightly wider than the rear so I could mildly IMSA the front fenders for heat release. Of course I maybe can’t leave that alone and maybe I will see if I can run 325s on the front also?
The plates for the upper control arms are clamped in place and needed a small trim to fit.
I actually left some really nice welds behind on this frame section.
https://lateral-g.net/forums/attachm...1&d=1618622591