I didn't have much time tonight but I decided to go out to the garage.
I decided to run the GPS sensor for the Holley dash since it is a simple project.
For now I just mounted the wires near the back of the dash.
Well, I know I should have went out to the garage as I ended up being out there way to long.
I started running wires from the ECU to the brake light switch (still not connected) and the ignition hot wires over to the fuse panel.
I also started running the Additional output wires to the P-Side kick panel
Made another hole in the car.
Labeled all of the wires with Heat Shrink wrap.
Started planning the DBW routing.
More Instruction that I need to sit down and read.
Pictures for reference.
Wires
Plugging it all in.
I recently started my bucket of shame
Let's not forget the vacuum line...ugh
Just in case you all were interested in the part #'s of the heat shrink tube I am using.
Calling it even thought I was only going to be out in the garage for a short period of time I stayed a little longer and got a bunch done.