I want to make the car as easy to work on as possible so, I am spending a little bit of time now that will hopefully save me time in the future.
If you go way back you will see that I ran all of the wires that go into the trunk through the drivers side rear quarter. This enabled me to pull
the wires out through "B" pillar vent. Which made it easy to wrap each wire loom individually and pass it over the wheel tub into the trunk.
Eventually I moved over to the wires in the trunk.
I used weather pack connectors on all connections.
Of course I labeled everything.
I had hoped to finish this project but unfortunately it was late and I needed to get up early in the morning so I called it a night.
side note.
Yep, I actually got stuck in the trunk when I was doing this and nope I couldn't reach my phone to call my wife to help me get unstuck.
Eventually, I just relaxed for a couple minutes (which felt like an eternity) and I was able to unwedge my elbow from the rear quarter.