A couple weeks ago I was reading one of the new magazines that are still in print and low and behold they shared a picture of
how Holley wants you to plumb the tank vent.
Now if I could actually figure out the part number for the fuel tank filler neck.
Since I am still using the factory Dimmer switch I ordered the all black version of this one.
It is finally time to bring the Anvil Carbon Inner fenders down from my Attic Office and yes the kitchen table is the perfect place to put them.
I needed to increase the gap in between the Holley Tank and the floor. So I used the Eastwood Sound deadening to increase the space just a little bit.
It's a good thing these trunk floors are so amenable.
Hopefully this will be the last time the radiator goes in the car.
So I forgot to flush the radiator so off to the spray wash to flush it out. I should mention it was only 6 degree's out and thankfully the spray
wash uses hot water. This of course made this a very tolerable.
I decided to lay the Anvil radiator cover on and it looks really nice. I will have to re-clear the radiator close out panel as it has yellowed.
