onward
welded 1/2 last night, other half tonight - and did it over a couple hours so I didn't get warping
pretty welds leak. My goal here was full penetration - thus the weld has some grey in it - key here is the HAZ is even (heat affected zone)
and all those black marks are holes - to check for leaks - I look for holes or HAZ changes
for whatever reason, this side didn't have any
then I put 7 or 8 psi in the tank, spray soapy water on the seams and blow bubbles
hmmm more bubbles
leaks fixed, clean up the tank.... next up, removal of the old tank eventually this will have tabs on the bottom so I can attach a defuser and also attach the rear panel to it
