[SuperB70]

Next task is to make outterskin of rear wheel tubs. Have glued tubs to quarters on earlier builds but now wanted to make them "right". Made them with flance to match the lip in original wheel archs. Glued again but now with 2k body adhesive.

Paper template, bead rolled edge and some stifnings. Tig welded and hammered. Used mig to hang them on. Hard to do by you self.
Made them as big as possible. Even had to cut down the top most outter corner so that quarters would fit.

Gray stuff is industrial grade epoxy paint. Body will be painted all over everywhere with that stuff.

Little tip again. Flancing hand tool. Just an old 1/2" socket T-handel, one end cutted off and slotted with 1mm cutting wheel. Piece of squar tube and small hose clamp make a easilly adjustable back stop. Just bend in little steps and go back and forward. Works great.

Now I can start hanging new quarters..