Quote:
Originally Posted by dhutton
Again, it has nothing to do with the display. The issue is a bus conflict which jacks up the ECM and generates codes etc…. Flaky stuff, just like you are describing.
Don
|
Gotcha. My original code I had was P18C2 for internal mode switch. I reset several times. Now that the switch has been replaced I get P18C2 "permanent".
Cannot reset. This is suppose to go away after several "cycles" and the ECU decides the repair is good. Nice to have a backup just in case. Wouldn't that be sweet if all I needed to do is change bus setting. Lol