Thank You and I was hoping that is what you would say. It looks like I am going to remove another 3/8" of the powder coating which will give me 1.25" of inward travel.
Quote:
Originally Posted by camcojb
So how far in does it go until it bottoms out? If it bottoms out before hitting the powdercoated section you're good. Dennys Driveshafts wants 3/4" for forward movement, so if the driveshaft is installed and car at ride height, if the powdercoated area is 1" or more back from the seal you're good.
Of course you can always sand some coating off to give yourself more room if needed. Tape off the clean part of the yoke and touch up the end of the powdercoating with matching paint, nobody will notice.
https://www.dennysdriveshaft.com/fre....html#faq_id10 |
:-)
Quote:
Originally Posted by sleepertime
  Except Marty will know... |