[Ricochet]

Well... Once again been lagging on the updates but still pushing on it.. At this stage I'm about 85% done with the wiring! Still need to button up some a few things in that department and tighten it up a bit... But coming out to my liking. I made a bolt in panel above the steering column that mounts all of the Dakota Digital module as well as the fan relays. Knowing how many things need constant hot, 12V switched hot and grounds - you will see in the middle of panel I set installed separate "Buses" if you for each. The top one is Constant Hot, the middle one switched hot & the bottom one is for grounds. There are covers that will go over each one when I'm done. The BigStuff3 management system is mounted to the right. The motor & trans wiring is 100% done! Just need to detail the fuel tank, install it, make a couple lines in the rear and hopefully make some noise!

Jim (aka The Painter) came by last weekend and we got the doors and trunk lid on. He did an amazing job on this. I can't thank him enough!! You can see him in the reflection!!! [emoji6]

Sent from my SM-G960U using Tapatalk