Once again I played with the intake tube so I can get the bracket made to support the intake tube.
I used the blue tape to reference where the tubes need to be once the clamps are tight. What you can't see is how
far I had to push everything into the couplers.
You can see where I plan to install the bracket from the fan shroud to the intake tube.
More ARP Hardware.
Apparently I forgot to tighten the exhaust clamps when Dr EFI Andrew was setting up the tune on the car. Good News
they are now tight and at the proper angle so they are above the frame rail.
Fuel Level Wiring complete
How could I have used this many tools
