It's all about the detail and being able to service / get to / find all of the wires if your on the side of the road broke down.
I need/want to route the wiring for the neutral safety switch through one of the shifter brackets versus around the bracket. Doing this will
direct it straight up to the firewall. I took a couple reference pictures so I don't have to try to remember where the wires plug in. The
good news is I can only actually screw up two of the wires.
Sorry this is a terrible picture but the bracket is laying on the carpet is the one that needs to be modified.
I started by using smaller drill bits stepping them up slowly till I got to the 5/8'' bit. I tried to use a step bit but that SOB ripped
the bracket right out of my hand.
Trust me using the 1/2 drill scares me but I did drill very slow.
After the hole was drilled I filed it into a square hole since no one make a square drill bit. Well that is a lie as the do
make them for wood working. Trust me look it up.
It took a couple tries to get the size correct.
A little bit of touch up paint.
