[syborg tt]

The retaining clip was bad so just a another simple fix. I wrapped the sensor 2x with 3M High Temp electrical tape so it doesn't vibrate off.



The intake tubes are coated so it's time to install them.



Bracket has been removed and for now it's getting rattle canned with Wrinkle Black. Over the winter I will
have the fan shroud and bracket powdered to match the Intake tube.







It's getting closer





I can't believe the stud lines up perfectly with the bracket.



Heading to Ace Hardware to get a USS Nut ( these are very thin nuts )



Final Assembly Time





While I am here I might as well install the MAF Sensor.





I also installed two High Density Urethane washers to help reduce vibration and I will be using a Nylock nut to retain this bolt..



Looks like things are lined up nicely.



So Close !!!

I can't seem to find the hose clamp for the filter and the best Amazon can do is tomorrow.