I had a little bit of time tonight so I went out and did another small project.
My plan is to add Techflex wrap to the battery wires to give it a finished look.
Need to get out the hot knife to recut Techflex wrap.
The yellow wire loop is strictly there to hold the terminal cover on. I plan to come up with a tag that says something funny or absurd.
Added a small piece of electrical tape to get the fuse at the right angle so I could easily see it.
All Better or should I say good enough.
I also removed the blue tape off the Anvil Carbon Inner Fender.
It's slowly but surely getting there.
I still need to figure out something for the ground kill switch.
