Unfortunately, the flat bar I purchased was zinc coated, so I could not tack it to the exhaust with my setup. [emoji2959]
Prior to realizing that, I made up a hanger. I made up a jig to bend the bar to curve round the pipe. I heated the bar up and then used a hammer to form it. I guess one of my next purchases will be a vise.
I planned on using grommets and rivnuts to secure the exhaust.
Using the tools and items I had available to me, it took almost an hour to make this one bracket and install the rivnut. All a waste since I can’t weld it to my exhaust. I have stainless flat bar ordered now.
Sent from my iPhone using Tapatalk