time to finish up the cooling system
plumb the tank
first, paint the mount
then the layout
Thursday, the stainless upper hose was in progress. Needed a bleeder as this is the highest point
because the metal is only 16 ga, I put a plug in the top then tapped it for the bleeder
finished here
you know, I could have finished this all pretty, but f*** that - gotta give the haters something to hate on
then a solid aluminum tube for the lower hose
once mounted
time to connect the AN side
on unfinished tasks.... painted the lower valence
we end on my favorite task... wiring... it was comforting to read that my plan will void the warranty
this isn't the void part... but I can't imagine putting the controller on the bumper support is a recommended procedure
grounding done (now we're voiding)
and the cooling system is holding fluid just fine...