Thread: Drill Bits
View Single Post
  #5  
Old 05-02-2025, 09:17 AM
raustinss raustinss is offline
Senior Member
  
Join Date: Dec 2013
Location: Kitchener ,Ontario
Posts: 847
Thanks: 54
Thanked 98 Times in 76 Posts
Default
stainless needs to be sharpened at a different angle than what you would want for mild steel 135 ish degrees for S.S. mild steel 120 ish . Also use cutting fluid lots of pressure on the bit and a slower drill speed
Reply With Quote
The Following 2 Users Say Thank You to raustinss For This Useful Post:
camcojb (05-02-2025), kwhizz (05-08-2025)