The only parts left stock on my car, are the very end caps of the firewall, the roof, A pillars and 1/4 panels. All else is fabricated and/or replaced with carbon fiber pieces. The entire floor, trunk, firewall ect is hand formed, so I won't be able to put anything that was stock back in place.
I built my car with a stict goal in mind- No messing with the geometry of placement of parts other than the way the C5R guys had it. So I built the entire car around the frame- this includes me widening the rear 1/4 panels by 2" per side to fit the wider track width of the transaxle/IRS setup.
That is why we call the car 50/50. The car is half Camaro and half C5 corvette, with a perfect 50/50 front to rear weight distribution.
I didn't mean to ruffle the feathers at all, just was curious on where you measured from to obtain that figure.
Keep up the good work, and get the car in the same country as you so you can beat on it!
Tyler
|