[Beach Cruiser]

Here's a picture of the two front ends before I pulled the car apart. I'm using the 84-85 components because they are a little narrower than the later years. Mine measures 59.5" hub to hub without the rotors. My camaro measures 60.5" hub to hub. My subframe has been upgraded to 70's vintage Monte Carlo brakes, rotors and Spindles. so the track may be a little different. (I did that in the 80's before all this new PT stuff was out on the market) I havn't gotten all the info back from my friend who is a Nascar Engineer on the new design, but no it's not the same as the stock vette. It's not far off, but I put the roll center about 2 inches above ground. I don't want to send you off in the wrong direction, because I havn't built the subframe yet, nor do I have valid numbers back from my friend. You can check on my progress in the Updates section. I'll be posting some pics tommorrow of the frame jig I built over the weekend.