I was driving my Camaro, shortly before it was sent back to the bodyshop, and noticed a glaring area where it needed improvement.
The cowl hood.
90% of us don't run the factory cowl vents on the hood since we aren't running the cowl-induction air cleaner. This means we are stuck with an undinished area of the hood that we have to stare at when driving down the road.
Somebody needs to make a part to close off this area, some sort of wire mesh with a frame that will bolt to the factory locations. It would really do a lot to clean up this area and give a finished look.
Thoughts?
A laser cut piece of stainless? A more elaborate solution? Who will solve this common first gen problem.
I know I would buy one
