I wish I could afford to have some machined. I talked to the guy at MAS on here, and He said it would run between 100 and 150 just for sleeves. I've got to leave for work in a bit. I am working on cleaning up the master for the wheels. The bumper is next. Hopefully I'll get a chance sunday to pour the molds.
To clean them up. I am hitting them with primer. Then sanding to finr the high and low spots. Sanding them out and re-priming. After they are cleaned up I'll hit them with a clear coat. that should give a nice smooth finish for the finished products when they are pulled from the mold.
If I decide to stagger the wheel sizes I'll have to go through this again. After I have the sleeves done, I think this might end up scaling out to 20" A bit bigger than I had planned, But generally on models, you have to size up a little bit for them to look right.
Last edited by black2002ls; 03-10-2006 at 01:11 PM.
|