View Single Post
  #465  
Old 01-23-2019, 04:08 PM
Coursey Coursey is offline
Member
 
Join Date: Nov 2010
Posts: 79
Thanks: 1
Thanked 3 Times in 3 Posts
Default

Quote:
Originally Posted by vannatta20 View Post
A 5th gen camaro e38 os will not support pwm. But a truck e38 os will. Also the e92 silverado controller will only support pwm at 100hertz. No discrete on the new stuff factory os.. The gmpp e92 controller will support discrete only. Its all super confusing and testing is the only way to know for sure. Lot of misinformation out there. I use an oscilloscope at work to see the signals. To get ac control the computer needs to get a serial on request from the bcm. We have a module the sends that signal along with tap shift commands for gen iv and gen v. This control the fan based on ac pressure as well. Works perfectly.
Quote:
Originally Posted by andrewb70 View Post
I'm pretty sure you don't need the controllers with the brushless fans. They have everything built into the motor controllers, so you just need to provide power, ground, and a PWM- signal. Presumably the PWM- should be configured the same as with a C6 controller. This is somewhat speculative on my part.

Andrew

So will the 2015 Camaro ECM put out a PWM signal?

Be great if it can go direct to fans with no control super simple that way.
Reply With Quote
The Following User Says Thank You to Coursey For This Useful Post:
yanyere (01-25-2019)