Quote:
Originally Posted by XcYZ
That's awesome, Rob. That intake is going to look killer on your motor.
The rotisserie... why I didn't buy or fabricate one for my project is beyond me.
What's the next step?
|
Thanks Scott...yes that rotisserie has paid for itself big time, in terms of saving my back...The next step will be to install the rearend housing (you might remember it's a DSE fabricated 9inch, the Qlink brackets are already on it) and locate/install the upper shock mounts...then send out the housing for powdercoat and while that's going on I will start in on the roll bar/partial cage, then prime the bottom of the car / apply bedliner material...and still have to make up my mind on the front subframe...so, there's still tons of stuff to do!
Paul, Ryan thanks for the kind words...The intake was a killer deal that I could not pass up; my project budget wouldn't normally allow for a custom sheetmetal intake, had it not come along, I was going to get my existing (cast) Dart intake modified for injector bungs, etc.