View Single Post
  #10  
Old 01-11-2022, 01:33 PM
SuperB70's Avatar
SuperB70 SuperB70 is offline
Senior Member
 
Join Date: Nov 2009
Location: Finland, Europe
Posts: 299
Thanks: 18
Thanked 69 Times in 28 Posts
Default

Getting low. -er.

as the plan is to get this car low, put still driveable low.
pre-measures shows it could be around 126cm/ 46" of total height.
Wheels and tires will effect it of course, but we'll see.

I got an idea to rise the rear frame rails above the rear axle.
To be able to rise the axle with out loosing suspension travel.
when mounted the body on the frame table,
I fab'ed adjustable stands, like jack stands.
Cut'ed the frame rails from rockers and from trunk edge.
Loose the original wheel tubs at this point also.

Leaving the trunk floor to stock location for now.
Then jacked it up 3".
Made pieces to fit the caps,
bead roller the edge to give same curve as stock rails..

After they where welded on, supported the rear panel from table.
I cut'ed the rear frame rails off, and floor under rear seat.
they where is good shape but they where too narrow for my plans.
Made new wider ones with magnetic brake. Again, with same kind of radius as stock ones. Now I can fit a tube in. Tube frame. That's coming, as are the bigger tubs.
Attached Images
          
__________________
Juhani
Custom Creations Oy (inc.)
CeeCeeOy IG page
Reply With Quote
The Following 2 Users Say Thank You to SuperB70 For This Useful Post:
camcojb (01-11-2022), syborg tt (05-18-2022)