So if this is correct
watts=amps x volts, I need a resistor to handle 300 watts at least
If E= IxR then 20 amps at 10 ohms would be a 200 volt drop?
I think there will be some trial and error to determine the correct resistance.
I would try a variable but they are over $300 for that power rating
I'll start with .5 ohms and see where that leads
According to Nu Relics low load is 5A, high load 11A, and stall is 20amps
I'm assuming low load is window down mode and high load windows up.
Thanks Don, let me know if that doesn't add up
|