View Single Post
  #2  
Old 03-19-2019, 06:42 PM
blown32's Avatar
blown32 blown32 is offline
Member
 
Join Date: Aug 2012
Location: Prescott, AZ
Posts: 45
Thanks: 2
Thanked 1 Time in 1 Post
Default garage door opening

First off you will most likely need building permits. I would contact a engineer to calculate the footings on each side of the garage door opening that will need to be increased to carry the additional weight from above. I would use a glu,lam beam, it would be nice if the garage wall was a framed 2 X 6 wall, you may be limited to the depth of the glu lam beam if you have a low ceiling height ( like a 8' plate height) if you have a 9' or 10' plate it shouldn't be a problem to install the proper size beam to carry the load. Relatively easy job depending on the exterior siding material, whether it's brick, stone, stucco or siding.
,
Reply With Quote