View Single Post
  #9  
Old 08-25-2018, 11:45 AM
dhutton dhutton is offline
Senior Member
 
Join Date: Nov 2006
Location: Mountain Springs, Texas
Posts: 1,857
Thanks: 985
Thanked 448 Times in 247 Posts
Default

Quote:
Originally Posted by J-440 View Post
The controller is set to go full blast at 3500rpm. Voltage is fine. Forgot to mention that the pump temp was at 175 degrees when everything else was at 250.
So you don’t know what your reduced voltage is? Haven’t you measured it?

If the heat sunk exterior of the pump is 175 you can bet the internal pump components are considerably hotter. If I had to guess I would say in excess of 300 degrees. This is based on 35 years of hardware design and countless thermal analyses and calculations....

Don

Last edited by dhutton; 08-25-2018 at 12:12 PM.
Reply With Quote