Ridetech single adjustable coil-overs mocked up. I really didnt like the factory bracing at all, and since there was no need for a spring bucket. I decided to get rid of it
Took some universal Ridetech mounts and moved the mounting point up
Mounts tacked in. I didnt change any geometry at all on the mounting point. just what they mount to.
Support bar tacked in
I had debated about doing this, but finally grew a pair and went for it!
1/8" plate fit up
After cutting the factory spring bucket out, this chows the nothing that is in the frame, which i finished boxing in
Basically all done, have a little bit more to do, but not picture worthy
Also boxed in the rear lower control arm mount