Thread: PWM cooling fan(s) control using ECM
View Single Post
  #477  
Old 02-19-2019, 08:19 PM
dhutton dhutton is offline
Senior Member
  
Join Date: Nov 2006
Location: Mountain Springs, Texas
Posts: 1,857
Thanks: 993
Thanked 451 Times in 249 Posts
Default
The voltage swing of the active low PWM signal would be determined by the voltage the pull-up resistor etc is connected to. If you connect it to 12 volts you will get a 12 volt signal.

Don
Reply With Quote
The Following User Says Thank You to dhutton For This Useful Post:
ldellhest (02-22-2019)