Quote:
Originally Posted by GregWeld
Personally I think your choice of 1/16th tungsten is too small for the job you're working on - I'd be using 3/32nd... with the same size filler material. Your HAZ (heat affected zone) is pretty wide - and that's due to slow travel speeds (typical of "newbs"). That's not a disrespectful name btw.
|
I thought the same thing, but decided to give it a try. That was going off the Miller welding app suggested sizes and settings. I do think I will switch back to 3/32 electrode on the remaining sides. Still gotta figure out how to get into the tight angle to weld it. Any suggestions?
I have been tig welding off and on for about 12 yrs now, but only do it at home on my own stuff and some side odd and ends.