Is this for an actual Mustang II?
I typically use RideTech upper and lower control arms with their coilovers as that allows me to fine tune the spring rates as needed but I have never tried to put them on a original Mustang II. I am sure they will work but I don't know if that fits with in your capabilities.
Depending on your ride height goals, I think I would consider dropped spindles as well and then run a taller coilover to get a bit more compression travel than stock.
*** checked your build thread. I think that is the way I would go. You may have issues with the rack boots and inner tierods clearing the control arm bushings. You will have to gusset the new LCA mounts and I would strongly consider adding a double shear bracket for the rear LCA bushing. I would also move the passenger side rack mount a 1/2" to allow the use of the fox body rack.
__________________
Donny
Support your local hot rod shop!
Last edited by dontlifttoshift; 10-18-2022 at 08:56 AM.
|