View Single Post
  #9  
Old 01-07-2013, 09:45 PM
Tony V Tony V is offline
Senior Member
 
Join Date: May 2009
Location: Arizona
Posts: 143
Thanks: 0
Thanked 29 Times in 11 Posts
Default

ok i'm going for the smooth look but with one exception....i plan on using bulkhead connectors for the engine harness and the ISIS harness therefore recessed the area behind the intake manifold so i can hide as much of the wiring as possible...

cutting out the necessary items to get a flat surface.


transfered my cardboard cut out to sheetmetal



Cutout for the tunnel....this is where i had to fit the new tranny and decide how far i had to move the tunnel..


with the tunnel adjusted i started piecing the recessed panel in to get an idea how it was going to line up...


note from my wife....



solution...so i put them to work on the Camaro..



I think it would've gone much faster if i had any sort of welding skills but i finally made it through and I like the way it came out...
Reply With Quote