I'm starting to get pretty good at this Sketchup stuff...
Here is where I'm at now. 1/4" steel bench top 30x48 with a 24" slide extension out each end and two bar mounts out the front for vices, grinders etc. The top is 33" high. The outer blocks on the bottom bar are 4" floor locks and the inner blocks are 4" locking casters (2 swivel, 2 rigid).
I'll add diagonal gussets in later where needed for strength.
Now, I just need to figure out what material to get...
A trip to IMS yesterday led me to two choices.
Smaller choice is 2 x 2 x 3/16" square tube for majority and 1.5 x 1.5 x 11 ga for the pieces that slide into them.
Larger choice is 2.5 x 2.5 x 1/4" square tube for the majority and 2 x 2 x 1/4" for the pieces that slide into them.
I want it to be heavy enough that it won't be moving around when cranking on something in the vice and was leaning toward the big stuff because of this...until I got the quote!! The bigger material bill is more than double the little bit smaller material.
So I'm leaning toward the 2 x 2 and 1.5 x 1.5 sq tube option. Any thoughts on this?