View Single Post
Old 02-28-2020, 12:50 PM
nickcornilsen's Avatar
nickcornilsen nickcornilsen is online now
Join Date: Oct 2011
Location: Portland, OR
Posts: 67
Thanks: 0
Thanked 5 Times in 4 Posts

To remove the skins, use an angle grinder and grind along the edge of the door. you'll get through the hemmed edge very quick. Then dress the spotwelds, etc.

Sandblast the lip and inside the door, apply a good epoxy primer.

Don't waste your money on a crimper - get a good door skin hammer and dolly, and do it by hand. you want to make several passes to slowly fold the edge over.

Once you've folded the edge over, put the door on the car,make sure it lines up. Then spot weld to lock the position in.

If you're doing adhesives... get a slow one, and work quick!

Wanted - F-Body LS1 oilpan/pickup/baffle
Reply With Quote
The Following User Says Thank You to nickcornilsen For This Useful Post:
camcojb (02-28-2020)