So my plan was to have the car completed for the Hot Rod Power Tour.
However, that didn't happen but the good news is I did buy the tires and plan to have them mounted soon.
Jumping back on the brakes or should I say "Circling Back".
I needed to stop this bracket from twisting when I turn the wheel
Step One - Dill second hole in the bracket.
Step Two - Tap said hole.
Step Three - Drill second hole in frame.
Step Four - Mount bracket using the ARP bolt and then thread in the smaller bolt so it acts like a stud in the bracket. That way if the small bolt
breaks all I have to do is replace it. I also don't have to worry about breaking a small tap in the frame as I have done that some many times in
the past that I no longer trust myself.
Step Five - Rinse and Repeat on the Drivers Side
Yahoo I get to use my Right Hand Drill
