My plan is to plumb the C6 pressure sensor into one of the two lines going in and out of the condenser. On my Vintage Air condenser, there is a larger (-08 EZ Clip) line on the top of the condenser that comes from the compressor. At the bottom is an -06 line that goes into the drier. From the drier, another -06 line goes into the under dash unit. My understanding is that the C6 pressure sensor should go to the -06 line coming out of the drier as it goes into the main under dash unit.
Is this the correct location for it?
The trinary switch from the initial relay non PWM fan system is at the top of the drier. Is there any need to switch back to the original binary switch or just leave the 3rd wire disconnected?
__________________
1971 Firebird
2017 SS
|