I built a 356 speedster years ago for my wife. It was a CMC replica but sure looked nice when I finished. Anyhow. It sure seems that if your going to do this kind of install that the whole floor and firewall will be removed leaving just a outer shell. It seems that you would be able to move the seats towards the doors a little and have enough room for the torque tube. The tube is not that big anyhow. I know the seats in these Porsches are mounted towards the center of the car so they sit down in the pan but with this kind of car you might can remove those huge rockers and move the seats over. I would hate to under take cutting that car in half. Go get a flared fiberglass tube for $2000 rather than cutting that original. Its going to be killer project no matter what you do.
Mike
|