Thread
:
57 Nomad Project
View Single Post
#
89
02-21-2016, 03:03 PM
kwhizz
Lateral-g Supporting Member
Join Date: Nov 2005
Location: Kenosha , wi
Posts: 1,095
Thanks: 641
Thanked 411 Times in 158 Posts
Got the drivers side fresh air vent cover plate installed.......I added a slotted area for the harnesses that needed to go inside the car......worked out perfect, after proving everything out I will seal it up with urethane........I also got the Dakota Digital gear sensor installed and hooked up inside the car along with a couple loose ends.....so.....all the wiring is completed inside the car......I just have to get the drive by wire pedal installed........so I decided to get the A/C and Defroster vents installed and put the gauge cluster back in.......everything works......even the check engine light (MAF) sensor not installed along with the gas pedal plug)........Getting Closer......Here are a bunch of Pic's
__________________
A couple previous builds
http://ls1tech.com/forums/conversion...2-install.html
http://www.yenko.net/ubbthreads/ubbt...453#Post455453
Ken
kwhizz
View Public Profile
Find all posts by kwhizz