Thread
:
My Cuda Project Part II...now at Bruning Auto Design
View Single Post
#
428
04-09-2013, 03:05 PM
DRJDVM's '69
Senior Member
Join Date: Jul 2004
Location: Manteca, CA
Posts: 1,299
Thanks: 2
Thanked 48 Times in 26 Posts
Fuel lines and mount for the regulator was next. I wanted to run the reg in back and have a short return line. There is not a ton of room back there, so I elected to mount it to the tank itself. I used the Pegasus Racing PTFE lines and fittings....damn that stuff is expensive !!
I am alittle concerned about how close the tank is to the diff.....I had to take the big Moser cover off and use a standard stamped cover. Everything clears but if I ever get rear ended, the diff is going to hit the tank pretty quick. The pix make it look closer than it ..there's a good 1.5 inch between the closest piece and the diff throughout the range of motion. I made a heat shield between the reg and exhaust too.
__________________
Ned
Manteca, CA
My '69 Camaro
My Camaro Movie
My '70 Cuda Project Thread
Bruning Auto Design
,
Air Ride Technologies
,
Rushforth Wheels
,
Vintage Air
,
Comp Cams/F.A.S.T
Carter Hickman Designs
,
Hurst Driveline Conversions
DRJDVM's '69
View Public Profile
Visit DRJDVM's '69's homepage!
Find all posts by DRJDVM's '69