Shaker scoop mounting
Greg,
I bought the original Blockers popsicle stye and it was junk
It did not even fit right under the shaker.. looks like what
you are looking at is a lot better
I ended up doing something like Byan cutting a bottom plate
to fit where the whole wants to be.. my car has a dominator
based carb with 4150 bowls for 1050 or 1150 cfm on the
CV1 manifold so it is really big and set far forward
I then grafted the shaker over the top by gluing oak pieces
up in it and then put threaded rods thru my home made
assembly (see attached pic of air filter)... air filter is a 3"
round that I made into an oval.. hard to describe but it works
I recently changed the Trans in my car and also the trans
mount so the motor is at 2.9 degrees down vs almost 5 before
and the front slightly hits my hood.. need to trim it a little
I can pull things apart to show you if you want more info
but looks like the Butler thing may work for you
Bob
|