View Single Post
  #23  
Old 04-02-2014, 02:19 PM
67Rally's Avatar
67Rally 67Rally is offline
Senior Member
 
Join Date: Oct 2010
Posts: 137
Thanks: 0
Thanked 1 Time in 1 Post
Default

Just an update...I ended up making a driveshaft safety loop out of 1/4"x2-1/2" steel plate. I got the solid loop from Jegs, and the rest is bar stock. I mounted this between the T56 mount and the trans itself. I thought I'd get lucky and make a straight run back, but the loop needed to be about 1" higher than the front mount.

Jegs loop:


Bar stock:




Basic shapes:


This is what I came up with:




Here it is installed:





Notice the hack job on the exhaust H-Pipe. That's not my work, and yes I paid to have that done. When I get back from Jamaica, it's going to a real exhaust shop and I'm having them install a Magnaflow X-Pipe, with new pipe running from the new headers to the existing Magnaflow mufflers.
Reply With Quote