Now on to the Frame notch.
We geusstamted on where we would need to cut the notch with some tape. then we removed the engine.
I then put the A/C bracket and compressor ( which got ordered the day we took the engine out.) on the motor to try and see how we did with the tape.
Next was to brake out the air tools! We made some cuts.
Big cuts!!
First cut.
Need more
Second cut
Needed more
Final cuts
The small opening over the lower control arm will be filled in with 1/8"-3/16" plate, then the finish pocket for the A/C will be made in the same material.
That's where we stand right now .