View Single Post
  #8  
Old 12-27-2012, 11:14 PM
Che70velle's Avatar
Che70velle Che70velle is offline
Senior Member
 
Join Date: Aug 2012
Location: Dawsonville Georgia
Posts: 2,219
Thanks: 609
Thanked 157 Times in 109 Posts
Default

On to the rear end coilover setup. I removed my factory upper spring bucket brackets first. I then installed a crossmember after many measurements were taken. This crossmember was inset into my frame with a holesaw, instead of flush mounting it, on each side for strength.





I then braced this crossmember to the factory crossmember diagonally.

__________________
Scott
---------------------------------------------------------------
70 velle' on custom chassis w/custom RideTech coilovers, RED sleeved 434” with Mamo 265’s, F-body Magnum, 12 bolt 3:73, wilwood 6/4's, bla, bla, bla...build. thread https://lateral-g.net/forums/showthread.php4?t=39631
New 434” engine build here https://ls1tech.com/forums/generatio...ved-block.html

Thanks Dad!!

My Chevelle is old school... It has a belt driven power steering pump.
They're 17's, but I keep em clean!
Reply With Quote