I have a question that I have to ask....
You have taken the time to blast the car to bare metal, then you do all the mock up and fabrication work with it still in bare metal. I noticed in some of the pictures that the guys are not wearing gloves while working on the car and I can already see rust forming where there finger prints are.
How do you prep the car before primer when you are done with all the fabrication and it is time for body work to commence?
You guys do amazing work. I am trying to learn how some of the shops handle this since I see so many cars in bare steel for so long at this stage. I was always taught that once blasted it is best to epoxy/etch the parts asap. I also always wear latex gloves when working with bare steel so I don't leave those finger prints in the steel.
Thanks,
Glenn
|