Well... Once again been lagging on the updates but still pushing on it.. At this stage I'm about 85% done with the wiring! Still need to button up some a few things in that department and tighten it up a bit... But coming out to my liking. I made a bolt in panel above the steering column that mounts all of the Dakota Digital module as well as the fan relays. Knowing how many things need constant hot, 12V switched hot and grounds - you will see in the middle of panel I set installed separate "Buses" if you for each. The top one is Constant Hot, the middle one switched hot & the bottom one is for grounds. There are covers that will go over each one when I'm done. The BigStuff3 management system is mounted to the right. The motor & trans wiring is 100% done! Just need to detail the fuel tank, install it, make a couple lines in the rear and hopefully make some noise!
Jim (aka The Painter) came by last weekend and we got the doors and trunk lid on. He did an amazing job on this. I can't thank him enough!! You can see him in the reflection!!!
Sent from my SM-G960U using Tapatalk
__________________
Brent
Last edited by Ricochet; 02-26-2023 at 10:31 PM.
The Following 7 Users Say Thank You to Ricochet For This Useful Post:
Here are some pics of the motor. Aside from the heater and AC lines everything is done. I'll be getting the steering column painted and back in the car this weekend. There is a painted (Body color) shroud that goes around the radiator and AC Condenser. Waiting until the lines are done before installing.
Sent from my SM-G960U using Tapatalk
__________________
Brent
Last edited by Ricochet; 02-26-2023 at 10:42 PM.
The Following 11 Users Say Thank You to Ricochet For This Useful Post:
Once again... Lagging on the updates... But still plugging away. Started putting the bright work on the car. Very happy with the way it pops off this color! After finishing the back side of the fenders with bedliner material we got them hung. Starting to look like something. Notice the body line we extended from the fender into the door 17" to mimic Bel Air molding. Headlights installed went with Dapper Lighting OE7. These are extremely nice units. And their customer service was second to none. On to the inner fenders this weekend...
Sent from my SM-G960U using Tapatalk
__________________
Brent
The Following 9 Users Say Thank You to Ricochet For This Useful Post:
Brian Hobaugh SCCA National Tour June 2014
First Hemi 'Cuda Convertible Ever Built
Short clips: Goodguys Pleasanton autocross and pit videos
It's like a ball of yarn unwinding, that has no end... Author DKz Garage
Linear Mode
