Drove to Eau Claire on Saturday to meet Kurt. He’s been busy mocking up various things: vintage air unit, clutch and brake pedal assemblies, making bracket for drive by wire throttle pedal, installing seat brackets, steering column, etc. He wanted me to stop by and check out seating position. Everything felt great, although we’re going to take 1/2” of height out of the seat brackets. We also mocked up the digital dash to make sure we head a clear line of sight. Took some pictures to give you an idea of things. The steering column in the attached pictures is not set completely in place - it will be about two inches closer to the firewall than shown here. The steering wheel is not what I’m using, either, but an extra that Kurt had lying around the shop.
In this picture, you can see the work he did to fill in the dash where the factory radio and ash tray were located.
Here is a shot from the driver seat... digital dash is going to work awesome!
Here is a picture of driver seat installed... they turned out great and fit the car really well. Height of seat is perfect.
Here is a picture of Momo wheel that I’m using...
This week he will be mocking up the air conditioning condenser, drier, etc, as well as finishing up some work on the firewall before paint, which is getting closer. He’ll also finish test fitting all of the headlight bezels, parking light bezels, grille, etc.
Sent from my iPad using Tapatalk