vintage air blower stays on low
i have installed a gen iv in a first gen camaro. i had one issue with the ecu being bad right away, vintage took care of that.Now while i've tried to program it multiple times, the blower motor stays on low with the key in the on and run positions. the controls do not adjust at all, i am using the retrofit slide pots for the controls. i have check the pots with a ohm meter and the resistance does change sliding the controls from one extreme to the other. my unit is wired direct to the battery( both pos & neg), the switched wire is directly to the ign switch and have tried direct to the battery to rule out a bad switch. while programming the blower will change speeds when grounding the gray wire. if i remove the small white wire from the ground the blower motor will blow on high. anyone have any other thoughts?
|